> Not Working
> Odometer And Speedometer Not Working
Odometer And Speedometer Not Working
The worst part is that if I went car shopping with my insurance settlement, I would never get a car that is in as good of shape (mechanically, not cosmetically) and Whitey 2012-05-31 21:34:36 UTC #3 If it were my car, I would just let it go. These 2 plastic gears are a common place for failure of the odo. Lift straight up and be careful to grab the vertical plastic gear and set aside. have a peek at this web-site
mine goes in and out. I got a drill bit the same diameter as the shaft (7/64) to slip in behind, as I was removing the shaft. I just did, they totaled my 99 and would not fix it. Safety and security tips: Please remember to recycle all your used fluids at an appropriate recycling center. read review
Odometer And Speedometer Not Working
Then remove the 4 screws holding the clock cluster. The brass gear that rides on the plastic gear can sometimes slip on its shaft, so gently test it with your finger. They gave me enough to fix it myself. There are usually one of 3 reasons why they don't work.
- Don't loose focus.
- if i hit the trip again, it just starts ticking again...i wouldnt worry about it too much Top icnuthin Posts: 151 Joined: Sat Sep 18, 2004 9:32 am Car: 93 s13
- So, i take my car into my mechanic for an oil change (just had to guess at how close i was to 3,000 miles) and I ask him about it.
- Close Yeah, keep it Undo Close This video is unavailable.
- Also as a safety tip please remember anytime you are working on, around or under your car, to wear safety glasses and secure the car with wheel stops and approved jack
- after i replaced it my cluster and my sidemarkers started to work again.
- You know, what I was thinking is that I really just need someone to run a red light and total my car.
- This is the hardest of all the gears to replace, but will cost you only your patience, some time and some locktight.
odometer not working: must be something between that and the odo.yea what he said and its located on top of your tranny. To reinstall just take your needle nose pliers and slowly push back on. Actually you can pry it off or just take some needle nose pliers and pull. How To Tell Mileage Without Odometer When I thought about it later, I realized I wouldn't get that much form the insurance company for the car, and I would be stuck making car payments again.
Top WilkesEP3 Posts: 5 Joined: Sat Dec 22, 2007 5:08 am Car: 2004 Honda Civic Si EP3 Re: why would my odometer stop working but everythi ... (Ekinchheng) Quote Type to Odometer Not Working But Speedometer Works It took me about 1 hour to do it. Skip navigation UploadSign inSearch Loading... Check This Out I know what gear I'm in without my car having to tell me, and I guess I can just estimate when to get my oil changed, although it's rather inconvenient.
The mileage info in on a chip in the body control module so not affected at all. Odometer Not Working Ford F150 This causes the other numbers to move and often fall out. But only do this after all the assembly is in the speedo, not on the towel. and the odometer stops working for a few minutes (when i notice)...
Odometer Not Working But Speedometer Works
TaxDiva 2013-07-08 21:46:56 UTC #7 DrewQ-- Don't have an accident.
Also I like to push on the dash cluster from behind to aid in removal. Odometer And Speedometer Not Working So yeah, speed sensor: speedo and odometer. Digital Odometer Not Working The 2nd pic shows me lightly separating the space between the pot metal gear and speedo housing.
This is why you want some slack on the speedo cable. Check This Out The good news is that this is an easy fix, as demonstrated by YouTuber Chris Fix.If both your odometer and speedometer are not working, then it's likely your speed sensor needs He tells me that it'd cost so much in time and parts that I might as well not even fix it. These are easily installed and located near the back of your transmission. Odometer Not Working Illegal
With the shaft removed you can see the shinny spot where the pot metal gear was slipping and spinning. The cluster just reads it like a computer monitor, not the computer itself. Remove the oil supply to the gauge with a 10mm wrench. Source Top hbpignosePA Posts: 3498 Joined: Fri Dec 01, 2006 6:07 pm Car: 90 240sx hatch (Jackstand Queen), 78 Datsun 280z (RIP), 89 cressida (Sold) 86 200sx hatch (sold) 83 280zx turbo
Remove the 2 screws holding the gauge cluster and the dimmer switch. Can Odometer Be Fixed So yeah, speed sensor: speedo and odometer. Of course laws pertaining to this vary by state, so it might be a good idea to get it fixed so you can sell it later.
The cluster can move forward allowing you to get your hand behind.
I know its been a little dull lately but really? The longer I go without knowing my mileage, the farther afield an estimate will be. This space is where you must get 1 drop of locktite. Odometer Doesn't Work The finished product installed and working great!
Home Categories FAQ/Guideline But the plastic gears that turn an analog odometer have a tendency to break, which causes the odometer to stop spinning. So follow along with my pictorial and fix it yourself. have a peek here So it started fading a little, then on some days it wouldn't light up at all.
General discussion forum about the 240sx, and a great place to introduce yourself to the board! Vq35de Re: why would my odometer stop working but everythi ... (Didderson) Quote Postby icnuthin » Sun Sep 23, 2007 6:39 am Didderson wrote:Maybe it's the odometer circuitry itself. Putting the geared shaft back into the number set and getting the pot metal gear back into position. Reach under the dash and gently pull the odometer cable an inch or 2 through the firewall.
So now what? After you do get all the gears in place then you must get a drop of locktite on the gear without getting any of it on or between the other numbers. The reason is the shaft must be taken out again if done on the towel. With the collar on slam tight it will prevent the shaft from turning properly.
Top ChuckNC Posts: 52 Joined: Sun Dec 31, 2006 6:30 pm Car: 1992 240sx hatchback Re: why would my odometer stop working but everythi ... (240monkey) Quote Postby ChuckNC » Sun Bing 2012-06-01 09:11:16 UTC #6 Again I think you've either got a bad digital cluster or a poor connection. Yeah, I was thinking the same thing about my 1998 Civic, and then the other day, I was next to a van when the driver decided to change lanes. Gently lift out the clock cluster and set aside.
The locktite will wick inside the gear. If your dimmer switch does not work, now would be a great time to replace it. I'm fine just driving around without it. I could be wrong about the mileage though..
Be mindful to not spill or splash fluids on yourself, others or the ground. Remove the hush panel under the drivers side dash. I know your odometer won't work if you have a bad speed sensor, but you say that all guages work fine including your speedometer. It is not on with great force to begin with.
Then insurance would cover me and the odometer would be low on my list of worries. But what do I do when I want to sell it or trade it in? That way your car will give out long before the odometer gives you any more trouble.Source: Chris FixRead Next: More FromCars Hybrid and Electric Share 'The Grand Tour' Is Leaving Crashed Also the phase gears you see next to the numbers riding on a second shaft, must also line up in the grooves of the numbers.